Sam4s ER-230 Series - Group Programming; Program 900 - Group Status Programming

136 • Contents Sam4S ER230 Series Electronic Cash Register AU
Group Programming
5 Group totals are available to accumulate totals of individual PLUs that are assigned to each group. Each PLU
can be assigned to one, two or three different groups.
• Program 900 - Group Status Programming allows to assign a group status, i.e. a group
can be set to not add to the total of all groups, or a group can be used to designate like
items for kitchen printer assignment.
• Program 910 - Group Descriptors Programming to assign a unique descriptor for each
group, so that the group may be easily understood on the group report.
Program 900 - Group Status Programming
1. Switch to P Mode by press MODE function key.
2. To begin the program, enter 9 0 0, press the SBTL key.
0 SBTL 0 9
3. Enter the number of the group you wish to program; press the X/TIME key.
X/T IME
4. Enter an option digit from the table below, press the SBTL key.
Address OPTION VALUE = SUM
Group total is added to the total of all groups on the
Group report?
Yes = 0
No = 1
N1
Send to kitchen printer?
Yes = 2
No = 0
No Choice
KP PORT#: R (print a kitchen requisition)
KP PORT#: 1
N2
KP PORT#: 2
0
1
2
4
N3
Print RED on KP?
Yes = 1
No = 0
ÚDefault values have been highlighted in bold print
N2 SBTL N1 N3
5. To program additional groups, repeat from step 3, or press the CASH key to finalize the
program.
CASH