Sam4s ER-230 Series - Program 711 - Macro Name Programming

144 • Contents Sam4S ER230 Series Electronic Cash Register AU
Program 711 - Macro Name Programming
Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To use three digit alpha character codes you must select ‘No’ in system
option #25 (See “System Option Programming”). Also see Descriptor Programming Methods
for Alpha Overlay and/or Descriptor Code Table.
Programming the Macro Name
Up to ten function locations may be designated as Macro keys. You may wish to program a name for a
macro. For example if a macro executes a series of commands to produce daily reports, you can
program the descriptor “DAILY”, so the macro can easily be identified. Macro names can also be
helpful when looking at keyboard layout information with the PC communication utility.
1. Switch to P Mode by press MODE function key.
2. To begin the program, enter 7 1 1, press the SBTL key.
1 SBTL 1 7
3. Refer to the chart below and enter the number that represents the Macro key Macro
1 you wish to program; press the X/TIME key.
X X/TIME
X Macro Key X Macro Key
1
Macro 1
6
Macro 6
2
Macro 2
7
Macro 7
3
Macro 3
8
Macro 8
4
Macro 4
9
Macro 9
5
Macro 5
10
Macro 10
4. If you are programming using alpha overlay,
Type up to 12
descriptor keys
SBTL
or,
SBTL
Enter up to 12
three-character codes
5. Press the CASH key to finalize the program.
CASH