Sam4s ER-230 Series - System Option Programming; Program 30 - System Option Programming

Sam4S ER230 Series Electronic Cash Register AU Program Mode Programming • 91
System Option Programming
Refer to the “System Option Table” to review the system options. Read each option carefully to determine if
you wish to make any changes. Default value has been highlighted in bold print.
NOTE: Because after Memory All Clear all options settings are automatically set to default, you do
not need to program this section unless you wish to change the default status.
Program 30 - System Option Programming
Programming a System Option:
1. Switch to P Mode by press MODE function key.
2. Enter 3 0, press the SBTL key.
3. Enter a system option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more than one
decision to be made in an address, add the values representing your choices for each
decision and enter the sum. Press the SBTL key.
5. Repeat from step 3 for each system option you wish to change.
6. Press the CASH key to end system option programming.
System Option Flowchart
SBTL X/TIME
Status
CASH
Repeat for each
System Option
Option #
SBTL 0 3
ÚDefault values have been highlighted in bold print