Sam4s ER-230 Series - Print Option Programming; Program 40 - Print Option Programming

96 • Program Mode Programming Sam4S ER230 Series Electronic Cash Register AU
Print Option Programming
Refer to the “Print Option Table” to review the print options. Read each option carefully to
determine if you wish to make any changes. Default value has been highlighted in bold print.
NOTE: Because after Memory All Clear all options settings are automatically set to default, you do
not need to program this section unless you wish to change the default status.
Program 40 - Print Option Programming
Programming a Print Option:
1. Switch to P Mode by press MODE function key.
2. Enter 4 0, press the SBTL key.
3. Enter a print option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more than one
decision to be made in an address, add the values representing your choices for each
decision and enter the sum. Press the SBTL key.
5. Repeat from step 3 for each print option you wish to change.
6. Press the CASH key to end print option programming.
Print Option Flowchart
SBTL X/TIME
Status
CASH
Repeat for each
Print Option
Option #
SBTL 0 4
ÚDefault values have been highlighted in bold print