2 • Getting Started Sam4S ER230 Series Electronic Cash Register AU
Unpacking
1. Unpack and unwrap the cash register.
2. Located in the packing are the following items:
• 1 roll of paper,
• 1 DC power supply,
• Operation and Program Manual,
3. Plug the DC outlet to cash register and AC end into a grounded outlet (three prong), press the
MODE key until indicater shift to the REG-Mode position.
Installing the Paper
1. Remove the printer Cover (A) and (B).
2. Open the housing clam cover by pressing the knob printer (orange button) (C) and (D).
3. Remove the used paper roll core if there is one.
4. Insert the paper roll as shown. Besure to note the correct direction that the paper comes off
the roll. Poll out a small amount of paper as shown (E).
To Next Page
Loading...
