Sam4S ER230 Series Electronic Cash Register AU Program Mode Programming • 131
Program 801 - Drawer Assignment & Training Clerk Programming
1. Switch to P Mode by press MODE function key.
2. To begin the program, enter 8 0 1, press the SBTL key.
1 SBTL 0 8
3. Enter the number of the clerk you wish to program; press the X/TIME key.
X/TIME
4. Enter an option digit from the table below, press the SBTL key.
N2 SBTL N1
Address OPTION VALUE = SUM
N1
Drawer assignment
(0: default drawer, 1: no drawer)
1
N2
Train Clerk
Yes = 1
No = 0
ÚDefault values have been highlighted in bold print
5. Repeat from step 3 for each clerk you wish to program. Press the CASH key to finalize the
program.
CASH
NOTE: When set to ‘0’ for default drawer, will show ‘1’ on the Program Scan - Clerk Scan,
‘1’ will show ‘2’, ‘2’ will show ‘0’.
To Next Page
Loading...
