Sam4S ER230 Series Electronic Cash Register AU Operating Instructions • 17
Clerk Sign-On/Sign-Off
See "System Option Programming” to review your clerk options:
• System option #2 allows you to select direct or code entry sign on.
• System option #3 allows you to select stay-down or pop-up operation.
Depending on how your machine has been programmed, sign-on will take place only at the
beginning of a shift (stay-down), or may have to be repeated for each transaction (pop-up). If
your machine has been programmed for stay-down clerks, the clerk currently signed on must
be signed off before another clerk may be signed on.
Check with your store manager to see which options have been selected for your register.
Before any transaction may take place, a clerk must be signed on. Clerk sign-on is
accomplished in one of two ways:
To sign On/Off Clerk, need to switch to REG Mode by press MODE function key.
Direct Sign-On
To sign on a clerk, enter the clerk number and press the CLERK key.
CLERK
Clerk # (1-5)
To sign the clerk off, enter 0 (Zero) and press the CLERK key.
0 CLERK
Coded Sign-On
To sign on a clerk, press the CLERK key, enter the clerk code, and then press the CLERK key
again.
CLERKCLERK
Clerk Code (up to 6 digits)
To sign the clerk off, enter 0 (Zero) and press the CLERK key.
0 CLERK
To Next Page
Loading...
