Sam4S ER230 Series Electronic Cash Register AU Program Mode Programming • 85
Program 300 - PLU Description Programming
Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To use three digit alpha character codes you must select ‘No’ in system
option #25 (See “System Option Programming”). Also see “Descriptor Programming Methods
for Alpha Overlay and/or Descriptor Code Table.
1. Switch to P Mode by press MODE function key.
2. To begin the program, enter 3 0 0, press the SBTL key.
0 SBTL 0 3
3. Select the PLU you wish to program in one of the following ways:
• Press a PLU on the keyboard, or
PLU
• Enter up to 15 digit number of the PLU and press the PLU key, or
PLU
Enter the PLU#,
up to 15 digits
• For a barcode item, scan the barcode.
4. If you are programming using alpha overlay;
Type up to 12
descriptor keys
X/TIME
or,
X/TIME
Enter up to 12
three-character codes
5. To program additional PLUs, repeat from step 3, or press the CASH key to finalize the
program.
CASH
To Next Page
Loading...
