3. Installation and Operation
SAM4S ER-350II SERIES 3-5
3-3 Operation
3-3-2 Initial Clear
The Initial Clear procedure clears keyboard lock-ups and clears most error conditions. This procedure finishes
the current transaction / operation and clears the Temporary Memory Buffers. An Initial Clear does not affect
register programming. Nor does it erase Totals stored in RAM memory
PROCEDURE
1. Turn the Mode key to the “S” position.
2. Connect the AC Power Plug into a power outlet while pressing the +%, VD and TAX keys.
(The pressing keys are buyer option)
3. After clearing all RAM memory the register prints the following line:
CAUTION: An Initial Clear causes balancing discrepancies if it is performed while in the middle of a transaction.
WARNING: If you ‘Power ON’ the ECR while the display connector on the PCB is open, the initial burst of
current may harm the system. The CPU is especially sensitive to power surges.
WARNING: Do an Initial Clear once only. Doing an Initial Clear more than once erases all programming and
Totals.
3-3-3 Service Mode Diagnostics
The Sam4s ER-350II series ECR offer several diagnostic routines while in the “S mode” Each of these tests
requires that the Mode key be in the “S Mode” position.
3-3-3-(a) Test Serial
1. Install the serial loop back test jig. (Short pin 2 & pin 3 and pin4 & pin 6 of DSUB connector)
2. Press 1000 and CANCEL key on the keyboard.
3. If error occurs, the message (NO GOOD) is displayed on VFD and the Buzzer beep, then press C key.
3-3-3-(b) Test Fiscal Memory Write
PROCEDURE
1. Fiscal Memory test requires that Mode Key be in the “S Mode” position.
2. Press the 3 key. Then press the CHARGE key. The Printer prints (on a receipt) the Fiscal EPROM checksum
data in the format shown below:
1effc 5a
1effd 3c
1fffe c3
1ffff
a5
### INITIAL RAM ALL CLEAR ###
To Next Page
Loading...
