Sam4s ER-390M - Program 80 - Function Key Descriptor Programming

178 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
Program 80 - Function Key Descriptor Programming
Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To descript by three digit alpha character codes you must select ‘No’ in
system option #25(for ER-3xx Series)/#30(for ER-230, ER-4xx and ER-52xx Series) (See
“System Option Programming). Also see Descriptor Programming Methods for Alpha Overlay
and/or Descriptor Code Table.
Programming the Function Key Descriptor
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 8 0, press the SUBTL key.
3. If you are programming ER-390M, ER-430M and ER-5200/ER-5200M
or,
If you are programming ER-230, ER-380 (EPROM v1.7 and later), ER-380M
(EPROM v1.4 and later), ER-420M and ER-5240/ER-5240M,
or,
If you are programming ER-380 (EPROM v1.6 and earlier), ER-380M (EPROM v1.3
and earlier) and ER-5215/ER-5215M,
4. To program additional function keys, repeat from step 3, or press the CASH key to
finalize the program.
NOTE: The MACRO (1 - 10) function keys descriptor is programmed with Programmed 711.
Please refer to Miscellaneous Programming - Macro Name Programming.
Type up to 18
descriptor keys
FUNCTION
KEY
ER-390M EPROM v1.012
ER-430M EPROM v2.1
ER-5200 EPROM v5.1
ER-5200M EPROM v5.1
and earlier
0 SUBTL 8
X/TIME
Type up to 18
descriptor keys
FUNCTION
KEY
ER-390M EPROM v1.013
ER-430M EPROM v2.2
ER-5200 EPROM v5.2
ER-5200M EPROM v5.2
and later
Enter up to 18
three-character codes
FUNCTION
KEY
X/TIME
Type up to 18 / 12 (ER-230)
descriptor keys
FUNCTION
KEY
Enter up to 18 / 12 (ER-230)
three-character codes
FUNCTION
KEY
Enter up to 18
three-character codes
FUNCTION
KEY
CASH