Sam4s ER-420 Series - Program 810 - Clerk Description Programming

140 • Program Mode Programming ER420 Series
Program 810 - Clerk Description Programming
Program descriptors by typing descriptors on the alpha keyboard overlay or by entering three
digit alpha character codes. To descript by three digit alpha character codes you must select
‘No’ in system option #25(See “System Option Programming”).
1. Turn the control lock to the P position.
2. To begin the program, enter 8 1 0, press the SBTL key.
0 SBTL18
3. Enter the number (1-15) of the clerk you wish to program; press the X/TIME
key.
X/TIME
4. If you are programming using alpha overlay;
X/TIME
Type up to 18
descriptor keys
or,
Enter up to 18
three-character
codes
SBTL
5. Press the CASH key to finalise the program.
CASH