ER420 Series Program Mode Programming • 155
CHECK Change Limit Programming
Use this program to set the maximum amount of cash that can be returned when a CHECK is tendered
for an amount greater than the amount of the sale. For example, if the CHECK change limit is $10.00
the maximum amount that can be tendered into the CHECK key on a $5.00 sale is $15.00.
Programming the CHECK Change Limit
1. Turn the control lock to the P position.
2. To begin the program, enter 1 2 0 0, press the SBTL key.
0 SBTL0 2 1
3. Enter a cash-in-drawer limit (up to 8 digits or 0 for no limit); press the X/TIME
key.
X/TIME
Enter the cash
limit, up to 8
digits
4. Press the CASH key to finalise the program.
CASH
To Next Page
Loading...
