Sam4s ER-420 Series - Date and Time Programming

156 • Program Mode Programming ER420 Series
Date and Time Programming
Use this program to set the clock and calendar on your ER420 Series. The date changes automatically.
After initial setting, time changing will probably be required only for beginning and ending daylight
savings time.
Programming the Date and Time
1. Turn the control lock to the P position.
2. To begin the program, enter 1 3 0 0, press the SBTL key.
0 SBTL0 3 1
3. Enter time in military standard time (based on 24 hours), must be four digits
(i.e. 1300 hours = 1:00 PM); press the X/TIME key.
H H X/TIMEM M
4. Enter the date in MM(month) DD(day) and YY(year) format. Press the
X/TIME key:
M M D D X/TIMEY Y
5. Press the CASH key to finalise the program.
CASH