Sam4s ER-430 SERIES - Program 110 - PLU Auto Tare Programming

Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU Program Mode Programming • 147
Program 110 - PLU Auto Tare Programming
NOTE: If this program has been performed, please also see Program 1400 - Scale Tare Weight
Programming in Program Mode Programming - Miscellaneous Programming for more
detail.
Programming PLU/PLUs Auto Tare
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 1 1 0, press the SUBTL key
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU on the keyboard, or
• Press the first PLU in a range of PLUs that are to receive the same setting then press
the last PLU, or
• Enter up to 15 digit number of the PLU and press the PLU key, or
• Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last PLU number in the range; press the PLU
key, or
• For a barcode item, scan the barcode. (Only for single item.)
4. Enter a value (between 1 and 5) to indicate the number of the preprogrammed tare weight
you want to automatically subtract when the PLU is used for scale entry (using an
optional scale). Enter 0 to disable automatic tare subtraction, follow with X/TIME key.
5. Program additional PLU Auto Tare, repeat from step 3, or press the CASH key to
finalise the program
CASH
0 SUBTL1 1
PLU
PLU
PLU
PLU
Enter the PLU#,
up to 15 digits
PLU
Enter the first PLU#,
up to 15 digits
Enter the last PLU#,
up to 15 digits
PLU
X/TIME
N