104 • Management Functions SAM4s SPS-300 Operator's & Programming Manual v1.34
Training Mode
A training mode is available so that the register can be operated (to practice registrations)
without updating totals and counters. If you choose to use training mode, you must set a
training mode password (see "Training Mode Password" in the "Program Mode
Programming" chapter.)
Note: If you make registrations to check tracking numbers in training mode, remember
that the check tracking total will be updated. Remember to pay, or clear the check file
(Reset Mode Menu/Z/Open Checks) before resuming normal operations. You must
close all open checks prior to entering training mode.
1. From the MANAGER MODE menu press 6 to enter or exit training mode:
ENTER/EXIT TRAINING
REGIST. IS CURRENTLY
NOT IN TRAINING
TO ENTER TRAINING
ENTER 4 DIGIT PASSWD
AND PRESS ENTER
2. The ENTER/EXIT TRAINING screen displays. The screen will display the
current status. To enter training mode, type your four-digit password (you must
enter preceding zeros) and press CASH. To exit training mode, type 0000 and
press CASH.
To Next Page
Loading...
