192 • Program Mode Programming SAM4s SPS-300 Operator's & Programming Manual v1.34
Function Key Programming
1. From the PGM control lock position menu, press 5 for FUNCTION KEY. The
FUNCTION KEY PROGRAM screen displays:
FUNCTION KEY PROGRAM
PUSH FUNCTION KEY TO
BE PROGRAMMED
2. Press the function key you wish to program.
If the function you wish to program is located on a function look-up key, press the
appropriate function look-up key, then press 1 to select STATUS PROGRAM (meaning
you wish to program the status of the function not the menu assignment of the function
look-up key) then press the digit corresponding to the function you wish to program.
To Next Page
Loading...
