Sam4s SPS-300 Series - Pbal

SAM4s SPS-300 Operator's & Programming Manual v1.34 Program Mode Programming • 211
CHECK # Key Program Notes
Option Entry Description
DESC
Alpha
numeric
12 character
You can program a unique descriptor. The default descriptor
is CHKTRACK.
KEY DISABLE Y or N Select Y to disable this function.
COMPULSORY
FOR ALL SALES
Y or N
Select Y you must begin a new, or recall an existing tracking
number before registering items.
OPENING CLERK
HAS EXCLUSIVE
ACCESS
Y or N
If Y, the clerk that begins a tracking number is the only clerk
who can recall a check. If N, any clerk can recall any check.
PRINT ON
RECEIPT
Y or N
If N, the check track number and balance will not print on the
receipt.
PRINT ON
REMOTE
Y or N
If N, the check track number and balance will not print on the
remote.
ALLOW ONLY
ONE CHK PER
TABLE
Y or N If Y, you can begin only one check with the same table #.
CHECK #
ASSIGNED BY
REGISTER
Y or N
If Y, press the CHECK. # key to automatically assign the
next sequential check. Check numbers will begin with #1 and
continue until the open check report is reset, at which point
the check number will be reset and start at #1 again.
DRIVE THRU
FEATURE
ENABLED
Y or N
If you wish to implement a drive thru recall key, this setting
changes the function of the PBAL key to that of a recall key.
Press the PBAL key directly to automatically recall the open
check with the lowest tracking number
LENGTH OF
CHECK (0-9)
Y or N
Set the length of check in number of digits. For example, if 4,
then checks must be used in the range from 1000, to 9999.
This setting applies only to check numbers input by the
operator, not to check numbers assigned by the register.
SCAN CHECK # Y or N
Choose Y to allow the check number to be input by a scanner
(must be nine digits or less).