SAM4s SPS-300 Operator's & Programming Manual v1.34 Program Mode Programming • 247
Clerk Report
The Clerk Report selection allows you to reprogram the descriptors that appear with the Clerk
Report totals and counters. For example, the first total on the clerk report "NET SALES"
might be re-labeled to say "GROSS SALES". You can reprogram any of the Financial Report
totals listed here with any 12-character descriptor.
1. From the LOGO DESC. PROGRAM screen, press 4 to display the CLERK
REP MESG. Screen:
CLERK REP MESSAGE 
TTL 1 :
NET SALE 
TTL 2 :
NONTAX
TTL 3 :
TAX1 SALES
2. The first 3 report descriptors (TTLs 1-3) display with the cursor arrow pointing at
the first descriptor. Using the alpha numeric keyboard overlay (SPS-320/SPS-
340, type the descriptor. For the SPS-345 use the descriptor code method (see
page 117.) Each descriptor can be up to 12 characters. If you make a mistake,
press the BACKSPACE key (on the alpha overlay or enter the backspace code
97 if you are using the descriptor code method) to erase the previous character.
After you have completed typing the first descriptor, press CASH to accept the
new message and advance to the next descriptor, or press CLEAR to return to
the LOGO DESC. PROGRAM screen without making any changes.
3. Press CASH repeatedly, or press PAGE UP and/or PAGE DOWN to locate the
descriptor you wish to program. After the last item on each screen, the screen
shifts to display the next 3 descriptors. (There are 52 Clerk Report descriptors
that you can program.) Using the same procedure, continue programming each
descriptor as necessary. Press CLEAR at any time to exit and return to the
LOGO DESC. PROGRAM screen.
To Next Page
Loading...
