Sam4s SPS-300 Series - Manager Operation; Reports

94 • Operations SAM4s SPS-300 Operator's & Programming Manual v1.34
4. Enter “0” and press the PLU key. The cursor will advance to the price field and
additional fields will display to allow entry of a unique descriptor and PLU tax
status. (Note: Group #1 Entry field added at software version 1.078.)
NOT FOUND PLU PROGRAM ?
SELECT COPY PLU
0
PRICE: 0
DESC :
TAX : 1N 2N 3N 4N
GROUP #1(1-20) 1
5. Enter the PLU price and press CASH. The cursor will advance to the descriptor
field.
6. Enter a descriptor using the descriptor method set up on your register (keyboard
overlay or descriptor code. See “Descriptor Programming Methods” on page
147.) After the descriptor entry, press CASH. The cursor will advance to the
TAX (1) field.
7. Press the YES/NO key to toggle the tax status from N(o) to Y(es). Set the status
for the four possible tax rates and press CASH.
8. Beginning at software version 1.078 you can enter the Group #1 group
assignment. Press CASH; the PLU entry is completed.
Not Found PLU Report
Managers will typically use the “Not Found PLU Report” as a tool to update the PLU file. A
list of up to 50 not found PLU items can be retained in the report. When capacity is reached,
you must clear (Z) the Not Found PLU report.
 To run an X Report of not found PLU’s, choose NOT FOUND PLU (selection
#8) from the Manager Mode menu
 To run an Z Report of not found PLU’s, choose RESET NOT FOUND PLU
(selection #7) from the Z Mode menu.