SAM4s SPS-300 Operator's & Programming Manual v1.34 Management Functions • 97
Management Functions
Introduction
All Management Functions take place with the control lock in the X position. In this way,
only those with the correct key will have access to these functions. Some register operations
may be programmed to require the control lock in the X position in order to operate. All
reports require a key that will access the X or Z position.
Manager Mode
 Turn the control lock to the X position to display the MANAGER MODE menu:
MANAGER MODE 
0.MANAGER OPERATION
1.X REPORTS
2.DECLARATION
3.REG. PRINT FORMAT
4.STOP RECEIPT PRINTING
5.STOP JOURNAL PRINTING
6.TRAIN MODE
 Press PAGE DOWN to display the second page of MANAGER MODE options:
MANAGER MODE 
7.E.J. OPERATION
8.NOT FOUND PLU
9.OPEN CHECK(IRC)
00.REPORT SD BACKUP
To Next Page
Loading...
