114 • Z Mode Sam4s SPS-300 OP Manual v1.35
PLU Lookup Program
You can assign up to fifteen PLU LOOK UP keys on the keyboard. (See “Function Key
Assignment” in the “Service Mode Programming” chapter.) Each of the PLU LOOK UP keys
can be programmed here to list specific PLU’s.
From the RESET REPORT MODE menu press 5 to select PLU LOOKUP PGM.
The PLU LOOKUP PGM screen displays:
PLU LOOKUP PROGRAM
PUSH LOOKUP NUMBER
TO BE PROGRAMMED
AND PRESS CASH
(1-15) 0
Enter the number of the PLU LOOKUP key you wish to program, press CASH.
1. 0
2. 0
3. 0
4. 0
5. 0
6. 0
7. 0
8. 0
With the cursor pointed at the first position of the PLU LOOKUP screen, select a
PLU by typing the PLU number and pressing CASH. The descriptor for the PLU
will display, and the cursor will advance to the next position.
1. PLU123
2. 0
3. 0
4. 0
5. 0
6. 0
7. 0
8. 0
Continue to select PLU’s for the PLU LOOKUP key as necessary. If you are editing
an existing PLU LOOK UP key, press CASH to advance the cursor without changing
the current line.
To Next Page
Loading...
