126 • Service Mode Programming Sam4s SPS-300 OP Manual v1.35
Function Key Assignment
Any programmable key location may be reprogrammed with a function from the list of available
functions on page 128 of this manual. The default program installs the functions as they are
shown with the standard key legends.
To change the function on a specific key:
At the SM control lock position menu, press 6 for Key Assignment programming.
The KEY ASSIGNMENT screen displays:
KEY ASSIGNMENT
PUSH KEY TO BE
PROGRAMMED
0
Press any key location. The current key assignment is displayed:
KEY ASSIGNMENT
KEY NUMBER : 322
CURRENT ASSIGNMENT
CASH
ENTER NEW CODE,
PRESS CASH
0
Enter a new key code from the list of "Function Key Codes" on page 128 and press
CASH, or press PAGE DOWN to display a list of key codes on the screen.
FUNCTION KEYCODE
--------------------------------
NLU#1 - NLU#150(1-150)
ONE 301
TWO 302
THREE 303
FOUR 304
FIVE 305
With the key code list displayed, you can press PAGE DOWN repeatedly, or PAGE
UP until you find the key code you wish to use. Type the key code number you wish
to place and press CASH. The KEY ASSIGNMENT screen displays again:
To Next Page
Loading...
