Sam4s SPS-300 Series - Flash ROM Updates

Sam4s SPS-300 OP Manual v1.35 Service Mode Programming • 129
IRC Options
At the S control lock position menu, press 7 for IRC Option programming. The IRC
OPTIONS screen displays.
IRC OPTIONS
REG# (1-8) 1
STORE# 000000
FROM REG# 1
TO REG# 1
IRC RETRIES(0-99) 3
#SHARE KP REG#(1-8) 0
Page 2 of IRC Options will display after the #SHARE KP REG# field is set:
IRC OPTIONS
#SHARE DATATRAN REG#(1-8) 0
Refer to the table below to fill the fields on the IRC OPTIONS screen.
Press the CLEAR key to finalize and return to the SERVICE MODE screen.
Option Entry Description
REG# 1-8 Enter the sequential number of the register in the IRC
System. Use “1” for a standalone register.
STORE# 6-digits Enter the store number
FROM REG# 1-8 Enter the number of the first register in the IRC range.
TO REG# 1-8 Enter the number of the last register in the IRC range.
IRC RETRIES 0-99 Enter the number of IRC retries. “3” is recommended
#SHARE KP
REG#
0-8 Enter the number of the register where the shared
kitchen printer is connected.
#SHARE
DATATRAN
REG#
0-8 Enter the number of the register where the shared
DATATRAN is connected.