Sam4s SPS-300 OP Manual v1.35 Program Mode Programming • 159
GROUP #1 PROGRAMMING
RESERVED
RESERVED
RESERVED
GIFT CARD(1-2) 0
1:ACTIVATE 2:ADD
AGE VERIFICATION (0-5) 0
Refer to the table below to fill the fields of the GROUP PROGRAMMING screens.
Press CASH to return to the GROUP PROGRAMMING screen. Continue to
program groups as necessary. Press CLEAR to return to the PROGRAM MODE
screen.
Group Programming - Reference Information
Option Entry Description
DESC Alpha
numeric
12 character
You can program a descriptor for each group. Type the
descriptor using the Program Overlay or by using the
descriptor code method (see page 147.). The overlay is
automatically activated when the cursor is pointing at
the DESC field. The default descriptors are GROUP 1,
GROUP 2, etc.
ADD TO GROUP TOTAL Y or N Select N if you do not wish this groups total to be
added to the total of all groups on the Group report.
SEND TO KP Y or N Select Y if you wish to send PLU’s reporting to this
group to a kitchen printer.
KP PORT # Y or N For SAT: Select Y or N to direct items to the device
attached to port 1-4 of the server register. Use the R
option (Y or N) to print a kitchen requisition at the
register.
For SER: Select Y or N to direct items to the device
attached to port 1-4 of a satellite register. (You must
set the register number where the KP is attached at IRC
programming, see page 128.)
PRINT RED ON KP Y or N Select Y if you wish items reporting to this group to
print in red on the kitchen printer. (Note, the kitchen
printer must have red/black printing capability, and this
option does not apply to the register receipt printer.)
GIFT CARD 0, 1 or 2 If a PLU in this group is used to register a new gift
card, select 1 for “activate”. If a PLU is this group is
sued to add a value to an existing gift card, select 2 for
“add”. For normal PLU registrations use the default
value of “0”.
To Next Page
Loading...
