200 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
CHARGE 1-8 Key Program Notes
Option Entry Description
DESC Alphanumeric
12 character
You can program a unique descriptor. The default
descriptors are CHARGE 1-8.
HALO 7-digit
amount
You can limit errors by setting the maximum amount
that can be tendered. "0" means that there is no
entry limit.
AMOUNT TEND COMP. Y or N Select Y if you want to force the operator to enter
the tendered amount and let the register calculate the
change.
ALLOW OVERTENDERING
IN MANAGER CONTROL
MODE ONLY
Y or N NOTE: Option changed at version 1.046 or later.
Before v1.046, this selection controlled both over
and under tenders. When selected, over tendering is
allowed only in the X control lock position.
DISABLE UNDER TEND. Y or N Select Y if you do not want the operator to tender
less than the amount of the sale.
DOES DRAWER OPEN Y or N Select N if you do not want the drawer to opened
with this key.
ALLOW OVER TEND. Y or N Select Y if you wish to allow tender greater than the
amount of the sale.
NON-ADD # COMP. Y or N Select Y if you wish to enforce the entry of a non-
add number prior to tendering.
EXEMPT TAX 1
EXEMPT TAX 2
EXEMPT TAX 3
EXEMPT TAX 4
Y or N Select Y to exempt the appropriate tax automatically
when finalized with this key.
COMPULSORY
VALIDATION
Y or N Choose Y to enforce validation if an optional printer
with validation capability is connected to an RS-
232C port.
CONNECT EFT Y or N Select Y if you want this key to send to total to the
connected DataTran device.
ALLOW UNDERTENDERING
IN MANAGER CONTROL
MODE ONLY
Y or N NOTE: Option added at version 1.046 or later.
Before v1.046, the selection on page 1 controlled
both over and under tenders. When selected here,
under tendering is allowed only in the X control lock
position.
SELECT (1:CREDIT
2:DEBIT, 3:GIFT,
4: GIFT NSF
5: CASH BENEFIT)
1, 2, 3, 4 (Only used when Send To EFT = Y)
Gift NSF indicates that a Gift card with a value less
than the amount of the sale will be accepted as an
under tender. (Applies to DataTran operations only.)
Cash Benefit function added at version 1.034.
SHOW TIP ON:
0:REG, 1:PINPAD
2:PRINT TIP LINE ONLY
0, 1, 2 Used only with EMV enabled applications.
To Next Page
Loading...
