238 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
Using the same procedure, continue programming each line as necessary. Press
CLEAR at any time to exit. After programming the third line, the fourth, fifth, and
sixth lines display:
PREAMBLE ↑
LINE 4 :
LINE 5 :
LINE 6 :
When the last line has been entered, press CASH to accept the line and return to the
LOGO DESC. PROGRAM screen.
Postamble
The postamble is a programming message of up to six lines of 32 characters that appears at the
bottom of each receipt and/or guest check.
From the LOGO DESC. PROGRAM screen, press 0 to display the POSTAMBLE
screen:
POSTAMBLE ↓
LINE 1 :
LINE 2 :
LINE 3 :
Using the alpha numeric keyboard overlay (SPS-320/SPS-340, type the descriptor.
For the SPS-345 use the descriptor code method (see page 147.) Each line can be up
to 32 characters. If you make a mistake, press the BACKSPACE key (on the alpha
overlay or enter the backspace code 97 if you are using the descriptor code method)
to erase the previous character. After you have completed typing the first line, press
CASH to accept the new line and advance to the second line, or press CLEAR to
return to the LOGO DESC. PROGRAM screen without making any changes.
To Next Page
Loading...
