Sam4s SPS-300 Series - Clerk Operations

Sam4s SPS-300 OP Manual v1.35 Getting Started • 33
6. The display reads: RAM (16M). After a short delay, the message: "OK” will display
if the RAM check is good. Memory is cleared, the default program is installed and
the RAM CLEAR receipt is printed. The display now reads:
2-STATION PRINTER : ‘CASH’ Key
1-STATION PRINTER : ‘CLEAR’ Key
7. If you have an ER-320 (one printer station), press CLEAR.
If you have an ER-340 (two printer stations), press CASH.
8. The display now reads:
AUTO CUT : ‘CASH’ Key
NO CUT : ‘CLEAR’ Key
9. Press CLEAR. (There is no ‘Auto Cutter installed.)
10. The SERVICE MODE menu displays. The RAM Clear procedure is complete and
the receipt prints:
• “ETHERNET LINK FAIL!!!” if the register is not connected to another register
in the network.
• The receipt will print the message: “ETHERET LINK SUCCESS!!!” if the
register is connected to another network register.
DATE 07/01/2011 FRI TIME 08:37
================================
RAM ALL CLEAR OK !
================================
RAM (16M) OK
FLASHROM INFORMATION
VERSION : USA 01.027
CHECKSUM : A6D8
BOOT/APP : 0806/9ED2
MAY. 10 2012
CLERK 00 000001 00000