SaMASZ SAMBA 280 Assembly Instructions

Page 10 of 10
MACHINE TYPE
SAMBA
No.
Action
Figure / Photo / Other
9
PTO
Install drive shaft onto transmission shaft (spline powering the
pulleys).
Push transmission shaft on spline until safety device is
engaged.
Install rubber guard on drive shaft (red
Couple rubber guard with shaft casing using metal clip:
- metal clip screwed 100 x 120
10
Blade mounting
lever
Place knife replacement lever on side wall of the linkage in
corresponding holder.
1. Insert lever handle through two rings welded on side
wall of the linkage.
2. Insert the other end of the lever handle in plastic
holder to prevent the lever from falling.
2
Handle
Splined shaft
Drive shaft
1

SaMASZ SAMBA 280 Specifications

General

Brand	SaMASZ
Model	SAMBA 280
Category	Farm Equipment
Language	English