ball link can be removed by using a flat screwdriver clicking it off again. Tape on
the tail cone.
• Adjust the tow hook to 100mm from the leading edge.
• Attach the wing with clear tape to secure at top and around leading edge.
• Check and adjust the CG (center of gravity). A suitable CG to start off is 99 for
F3B and 95 – 99mm for F3F from leading edge.
• Check range according to transmitter specifications.
If you can not get the necessary range you need to:
1) Check antenna locations
2) Try another transmitter
3) Try another receiver
Settings:
• All the latest detailed settings can be found on www.F3J.com.
These are settings from some of the world’s best pilots.
You will find these setting a very good starting point.
Model cannot stay in the sun without silver protection covers (including fuselage). Covers
prevent excessive heating of the model as there could appear some deformations of
model parts when model is overheated, or the surface could get distortions. If the reflex
painted parts are not protected against the sun, the reflex effect will fade much earlier
even if there is used layer of paint with UV filter
Joiner is made of high modulus carbon fibers UMS
After harder landings it is necessary to check the joiner and look for cracks as it could
cause failure of complete model in the next flights.
We hope you will be satisfied with your new model. If you have any questions be sure to
look at our webpages. Additional info about the setup and detailed pictures can be found
there.
Regards
Samba Model
Webpage: www.F3J.com / Email: samba@f3j.com
To Previous Page
Loading...