Samson 3730-2 - Enabling and Selecting Parameters

EB 8384-2 EN 115
Operating the positioner
7.10 Enabling and selecting parameters
Allcodesandtheirmeaninganddefaultsettingsarelistedinthecodelistinsection11.3.
CodeswhicharemarkedwithanasteriskmustbeenabledwithCode3beforetheassociat-
edparameterscanbeconguredasdescribedbelow.
Turn untilCode3appears(reading:No).
Press
, the code number 3 blinks.
ChangethesettinginCode3.
Turn
until YES appears.
Press
, reading:
Congurationisenabled.
Youcannowcongurecodesoneafterthe
other:
Turn to select the required code.
Press to activate the selected code. The
code number starts to blink.
Turn to select the setting.
Press
toconrmtheselectedsetting.
Code3
Congurationnot
enabled
Congurationenabled
Ifnosettingsareenteredwithin120seconds,theenabledcongurationfunctionbecomesin-
validandthedisplayreturnstoCode0.
Cancel the setting:
Tocancelavaluebeforeitisconrmed(bypressing ) proceed as follows:
Turn until ESC appears.
Press
toconrm.
The entered value is not adopted.
Canceling the reading