Samson 3730-4 - Page 28

Fault/diagnostic alarm
Default setting acc. to Pro
-
file 3.01 Condensed Status
Classified
Diagnosis
Yes No
Perhaps larger than in original state
(TEST)
0x80 GOOD_NON_SPECIFIC • –
Perhaps larger than original state
0x80 GOOD_NON_SPECIFIC • –
External leakage
Perhaps soon expected
0x80
GOOD_NON_SPECIFIC
•
–
Perhaps existing
0x80
GOOD_NON_SPECIFIC
•
–
Existing
0x80
GOOD_NON_SPECIFIC
•
–
Observing end position
Zero point shift monotonously down-
wards, average value above reference
lines
0x80 GOOD_NON_SPECIFC • –
Zero point shift monotonously upwards,
average value above reference lines
0x80 GOOD_NON_SPECIFIC • –
Zero point alternating, average value
above reference lines
0x80 GOOD_NON_SPECIFIC • –
Zero point shift monotonously down-
wards, average value below reference
lines
0x80 GOOD_NON_SPECIFIC • –
Zero point shift monotonously upwards,
average value below reference lines
0x80 GOOD_NON_SPECIFIC • –
Zero point alternating, average value
below reference lines
0x80 GOOD_NON_SPECIFIC • –
Connection positioner/valve
No optimal travel transmission (TEST)
0x80 GOOD_NON_SPECIFIC • –
Perhaps loose
0x80
GOOD_NON_SPECIFIC
•
–
Perhaps limit. range
0x80 GOOD_NON_SPECIFIC • –
Perhaps loose (TEST)
0x80
GOOD_NON_SPECIFIC
•
–
Range
Mostly near closing position
0x80 GOOD_NON_SPECIFIC • –
Mostly near max. opening
0x80 GOOD_NON_SPECIFIC • –
Mostly closing position
0x80 GOOD_NON_SPECIFIC • –
28 KH 8384-4 EN
Status alarms according to Profile 3.01 Condensed Status