Fault/diagnostic alarm
Default setting acc. to Pro
-
file 3.01 Condensed Status
Classified
Diagnosis
Yes No
Hardware error
x signal 0xA8 GOOD_MAIN_DEMANDED • DIA_MEASUREMENT
i/p converter 0x24 BAD_MAINT_ALARM • DIA_HW_ELECTR
Hardware 0x24 BAD_MAINT_ALARM • DIA_HW_ELECTR
Data memory 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Test calculation 0x24 BAD_MAINT_ALARM • DIA_MEM_CHECKSUM
Program loading error 0x24 BAD_MAINT_ALARM • DIA_MEM_CHECKSUM
Data error
Control parameter 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Poti parameter 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Calibration error 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Interal device error 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
General parameters 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Options parameters 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Info parameter 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
PA parameter 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Diagnostic parameter 0xA4 GOOD_MAINT_REQ • DIA_MEM_CHECKSUM
Extended diagnostics EXPERT
+
Air supply
Perhaps modified TEST 0x80 GOOD_NON_SPECIFIC • –
Perhaps not enough TEST 0x80 GOOD_NON_SPECIFIC • –
Perhaps not enough 0x80 GOOD_NON_SPECIFIC • –
Working at full capacity 0x80 GOOD_NON_SPECIFIC • –
Working at full capacity TEST 0x80 GOOD_NON_SPECIFIC • –
Perhaps modified 0x80 GOOD_NON_SPECIFIC • –
Actuator springs
Perhaps spring stiffness reduced TEST GOOD_NON_SPECIFIC • –
Perhaps bias reduced TEST 0x80 GOOD_NON_SPECIFIC • –
Perhaps bias increased TEST 0x80 GOOD_NON_SPECIFIC • –
Working at full capacity 0x80 GOOD_NON_SPECIFIC • –
Working at full capacity TEST 0x80 GOOD_NON_SPECIFIC • –
EB 8384-4 EN 101
PROFIBUS-PA communication
To Next Page
Loading...
