Fault/diagnostic alarm
Default setting acc. to Pro
-
file 3.01 Condensed Status
Classified
Diagnosis
Yes No
Observing end position
Zero point shift monotonously
downwards, average value above re
-
ference lines
0x80 GOOD_NON_SPECIFC • –
Zero point shift monotonously upwards,
average value above reference lines
0x80 GOOD_NON_SPECIFIC • –
Zero point alternating, average value
above reference lines
0x80 GOOD_NON_SPECIFIC • –
Zero point shift monotonously
downwards, average value below refer
-
ence lines
0x80 GOOD_NON_SPECIFIC • –
Zero point shift monotonously upwards,
average value below reference lines
0x80 GOOD_NON_SPECIFIC • –
Zero point alternating, average value
below reference lines
0x80 GOOD_NON_SPECIFIC • –
Connection positioner/valve
No opt. travel transm. TEST 0x80 GOOD_NON_SPECIFIC • –
Perhaps loose 0x80 GOOD_NON_SPECIFIC • –
Perhaps limit. range 0x80 GOOD_NON_SPECIFIC • –
Perhaps loose TEST 0x80 GOOD_NON_SPECIFIC • –
Range
Mostly near closing position 0x80 GOOD_NON_SPECIFIC • –
Mostly near max. opening 0x80 GOOD_NON_SPECIFIC • –
Mostly closing position 0x80 GOOD_NON_SPECIFIC • –
Mostly max. opening 0x80 GOOD_NON_SPECIFIC • –
Temperature monitoring
Lower limit exceeded 0x80 GOOD_NON_SPECIFIC • –
Higher limit exceeded 0x80 GOOD_NON_SPECIFIC • –
Reference run
Reference test aborted 0x80 GOOD_NON_SPECIFIC • –
ESD
Movement actuator possible –>
Masking redundant
0x80 GOOD_NON_SPECIFIC • –
Movement actuator impossible 0x80 GOOD_NON_SPECIFIC • –
Error solenoid valve 0x80 GOOD_NON_SPECIFIC • –
EB 8384-4 EN 103
PROFIBUS-PA communication
To Next Page
Loading...
