14.6 Acyclic data exchange
Note: All parameters in the parameter list on page 130 onwards, which are not marked, are
included in the acyclic data exchange.
The acyclic data exchange complying to DP-V1 with a master class 2 (MS2) is mainly used
for commissioning, parameter configuration and for diagnostic purposes.
The Device Description can be downloaded at the SAMSON Internet site (www.samson.de)
to configure parameters in Type 3730-4 Positioner over Siemens PDM (Process Device Man
-
ager). Some parameters make it necessary to use the new DD revision 2 for firmware version
K 1.11/R 1.45 and higher.
110 EB 8384-4 EN
PROFIBUS-PA communication
To Next Page
Loading...
