Samson 3730 Series - Adjusting inductive limit switch

EB 8384-3 EN 7-17
Start-up and conguration
Turn untilCode3appears(reading:No).
Press , the code number 3 blinks.
ChangethesettinginCode3.
Turn until YES appears.
Press , reading:
Congurationisenabled.
Youcannowcongurecodesoneafterthe
other:
Turn to select the required code.
Press to activate the selected code. The
code number starts to blink.
Turn to select the setting.
Press toconrmtheselectedsetting.
Code3
Congurationnoten-
abled
Congurationenabled
Ifnosettingsareenteredwithin120seconds,theenabledcongurationfunctionbecomesin-
validandthedisplayreturnstoCode0.
Cancel the setting:
Tocancelavaluebeforeitisconrmed(bypressing ) proceed as follows:
Turn until ESC appears.
Press toconrm.
The entered value is not adopted.
Canceling the reading
7.7 Adjusting inductive limit switch
The positioner version with an inductive limit switch has an adjustable tag (1) mounted on the
axis of rotation, which operates the proximity switch (3).
Foroperationoftheinductivelimitswitch,thecorrespondingswitchingamplier(seethe'In-
stallation' section) must be connected to the output circuit.
Whenthetag(1)islocatedintheinductiveeldoftheswitch,theswitchassumesahighre-
sistance.Whenitmovesoutsidetheeld,theswitchassumesalowresistance.