Samson 3730 Series - Removal

EB 8384-3 EN 12-1
Removal
12 Removal
The work described in this section is only to
be performed by personnel appropriately
qualiedtocarryoutsuchtasks.
Risk of fatal injury due to the ignition of an
explosive atmosphere.
Î The following regulations apply to instal-
lation in hazardous areas: EN60079-14
(VDE0165, Part1).
Î Installation, operation or maintenance of
the positioner must only be performed by
personnel who has undergone special
training or instructions or who is autho-
rized to work on explosion-protected de-
vices in hazardous areas.
Î Put the positioner out of operation (see
the 'Decommissioning' section).
Î Disconnect the wires for electrical input
and remove them from the positioner.
Î UnscrewthescrewttingsattheOut-
put38andSupply9portsoftheposi-
tioner.
Î To remove the positioner, loosen the three
fastening screws on the positioner.
DANGER
!