Samson 3730 Series - Configuration using the TROVIS-VIEW software

3-4 EB 8384-3 EN
Design and principle of operation
Either a HART
®
capable handheld communi-
cator or a computer with FSK modem can be
used to establish communication and oper-
ate the positioner.
The HART
®
device revision as well as the
indicating and operating modules sup-
ported by the Type3730-3 Position-
er can be found on the SAMSON website
(uwww.samsongroup.com > SERVICE &
SUPPORT > Downloads > Device integration
> 3730-3 > 'Device Revision' to 'Firmware'
assignment).
3.4 Conguration using the
TROVIS-VIEW software
Thepositionercanbeconguredwith
SAMSON'sTROVIS-VIEWSoftware.
The positioner has for this purpose a serial
interface to allow the RS-232 or USB port of
a computer to be connected to it using an
adapter cable.
TheTROVIS-VIEWsoftwareenablestheuser
toeasilycongurethepositioneraswellas
view process parameters online.
TROVIS-VIEW provides a uniform user inter-
face that allows users to congure and pa-
rameterize various SAMSON devices using
device-specic database modules. The de-
vice module 3730-3 can be downloaded
free of charge from our website at
uwww.samsongroup.com > SERVICE &
SUPPORT > Downloads > TROVIS-VIEW.
Further information on TROVIS-VIEW (e.g.
system requirements) is available on our
website and in the Data Sheet uT6661.
Note
Note