EasyManua.ls Logo

Samson 3730 Series - Page 26

Samson 3730 Series
216 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-6 EB 8384-3 EN
Design and principle of operation
Type3730-3 Positioner
The technical data for the explosion-protected devices may be restricted by the
limits specied in the test certicates.
Inuenc-
es
Temperature
≤0.15%/10K
Supply air None
Effect of vibration ≤0.25%upto2000Hzand4gaccordingtoIEC770
Electromagnetic compatibility
Complying with EN 61000-6-2, EN 61000-6-3, EN 61326-1 and NAMUR Rec-
ommendation NE 21
Electrical connections
OneM20x1.5cableglandfor6to12mmclampingrange
Second M20x1.5 threaded connection additionally available
Screwterminalsfor0.2to2.5mm²wirecross-section
Degree of protection IP66/NEMA4X
Use in safety-instrumented
systems (SIL)
Emergencyventingat0mAset
point and using optional
solenoid valve
ObservingtherequirementsofIEC61508,thesystematiccapabilityofthepilot
valve for emergency venting as a component in safety-instrumented systems is giv-
en.
UseispossibleonobservingtherequirementsofIEC61511andtherequired
hardwarefaulttoleranceinsafety-instrumentedsystemsuptoSIL2(singledevice/
HFT=0)andSIL3(redundantconguration/HFT=1).
Explosion protection Refer to Table 3-3
Communication (local) SAMSON SSP interface and serial interface adapter
Software requirements (SSP) TROVIS-VIEWwithdatabasemodule3730-3
Communication (HART
®
)
HART
®
Revision5(canbeswitchedtoRevision6)
Impedance in HART
®
frequencyrange:Receiving350to450Ω·Sendingapprox.
115Ω
Software
require-
ments
For handheld
communicator
DevicedescriptionforType3730-3
For computer
DTMleaccordingtospecication1.2,suitableforintegratingthedeviceinto
frameapplicationsthatsupporttheuseofFDT/DTM(e.g.PACTware);otherinte-
grations (e.g. AMS, PDM) available
Binary contacts
For connection to
For connection to the binary input of the PLC
acc.toIEC61131-2,P
max
=400mWorfor
connectiontoNAMURswitchingamplier
acc.toEN60947-5-6
NAMURswitchingamplieracc.
to EN 60947-5-6
Twosoftwarelimitswitches,reversepolarityprotection,oating,congurableswitchingcharacteristics(defaultset-
tings in table)
Signal
state
Version No explosion protection Ex
No response
Non-conducting ≤1.0mA
Response Conductive(R=348Ω) ≥2.2mA

Table of Contents

Other manuals for Samson 3730 Series

Related product manuals