Samson 3730 Series - Shipment and on-site transport; Accepting the delivered goods; Removing the packaging from the positioner; Transporting the positioner

EB 8384-3 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualiedtocarryoutsuchtasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Check that
thespecicationsonthenameplateofthe
positionermatchthespecicationsinthe
delivery note. See the 'Markings on the
device' section for nameplate details.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.2 Removing the packaging
from the positioner
Observe the following sequence:
Î Do not remove the packaging and the
protective caps on the pneumatic ports
until immediately before installation.
Î Dispose and recycle the packaging in ac-
cordance with the local regulations.
4.3 Transporting the positioner
Î Pack the positioner properly to comply
with terms of transportation.
Transport instructions
− Protect the positioner against external in-
uences(e.g.impact).
− Protect the positioner against moisture
and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture (see the 'Design and principle of op-
eration' section).
4.4 Storing the positioner
Risk of device damage due to improper
storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions.
We recommend regularly checking the con-
trol valve and the prevailing storage condi-
tions during long storage periods.
Storage instructions
− Protect the positioner against external in-
uences(e.g.impact,shocks,vibration).
NOTICE
!
Note