Samson 3730 Series - Page 95

EB 8384-3 EN 6-5
Operation
Table 6-1: Dynamic HART
®
variables assignment
Variable Meaning Unit
Reference variable Set point %
Valvesetpoint Set point depending on direction of action %
Target position Setpointaftertransittimespecication %
Valveposition Valveposition %
Set point deviation e Set point deviation e %
Absolute total valve travel Absolute total valve travel –
Binary input status 0=Notactive
1=Active
255=–/–
–
Status of internal solenoid
valve/forcedventing
0=De-energized
1=Energized
2=Notinstalled
–
Condensed state 0=Nomessage
1=Maintenancerequired
2=Maintenancedemanded
3=Maintenancealarm
4=Outofspecication
7=Functioncheck
Temperature Temperature °C
Leakage Sound pressure level (leakage detection) dB