Samson 3767 - Page 106

15-2 EB 8355-2 EN
Annex
Accessories Order no.
Pressuregaugemountingblock(onlyfor120cm²)
G¼ 1400-7458
¼ NPT 1400-7459
Pressure gauge mounting kit for supply pressure and signal pressure
Stainlesssteel/brass 1402-1637
Stainlesssteel/stainlesssteel 1402-1638
Filtercheckvalve,replacesventplugandincreasesthedegreeofprotectiontoIP65
Filtercheckvalveintegratedintoascrew-onbodywithG¼thread
Polyamide,
IP65degreeofprotection
1790-7408
1.4301,IP65degreeof
protection
1790-7253
Polyamide,
NEMA 4 degree of
protection
1790-9645
1.4301,
NEMA 4 degree of
protection
1790-9646
Assortment of spare parts including gaskets and diaphragms 1400-9895
Table 15-2: Accessories and mounting kits for attachment according to IEC60534-6
Mounting kits Control valve Travel [mm] With lever Order no.
NAMUR mounting kit,
seeFig.5-6forparts
Valvewithcastyoke
7.5to60 N1(125mm) 1400-6787
22.5 to 120 N2(212mm) 1400-6789
Rod diameter
[mm] of rod-
type yoke
20 to 25 N1 1400-6436
20 to 25 N2 1400-6437
25 to 30 N1 1400-6438
25 to 30 N2 1400-6439
30 to 35 N1 1400-6440
30 to 35 N2 1400-6441
Attachment to Fisher and Masoneilan linear actuators
(one of each mounting kits is required per actuator)
1400-6771
and
1400-6787
Additional range spring acc. to
Range spring 1 (9.5 coils, installed as standard)
Range spring 2 (4.5 coils)
1400-6442
1400-6443
Accessories Order no.
Pressure gauge mounting block
G¼ 1400-7458
¼ NPT 1400-7459
Pressure gauge kit
Stainlesssteel/brass 1402-1637
Stainlesssteel/stainlesssteel 1402-1638