Need help?Do you have a question about the Samson DMS80 and is the answer not in the manual?
General| Configuration | 2-Way |
|---|---|
| Speaker Size | 8-inch |
| Input Connectors | RCA |
| Connectors | RCA |
| Woofer Size | 8" |
| Tweeter Size | 1" |
Details all controls and indicators on the front of the DA80 amplifier, including switches, volume, and EQ.
Describes all input and output jacks and connectors on the rear of the DA80 amplifier, such as speaker out and line in.
Find a secure place for the DA80 and speakers; ensure proper airflow for vents.
Connect speakers to DA80 terminals using push-spring connectors, observing polarity.
Connect SUB OUT MONO to a powered subwoofer system using a shielded cable.
Connect the IEC cord to the AC INPUT after ensuring power is off and controls are minimal.
Connect keyboards, mixers, CD players, mics, instruments to LINE, AUX/CD, MIC/INST. inputs.
Depress the POWER switch to turn the unit on; check LED and troubleshooting if not lit.
Balance input levels by adjusting output levels and Master Volume for desired listening volume.
Troubleshoot power connection, fuse, or outlet issues if the unit does not power on.
Check cables, switches, volume levels, and speaker wiring for no sound when powered on.
Adjust volume levels and check sound card settings for low volume or distorted audio.
Check speaker impedance and wiring; low impedance can cause overheating and damage.
Identify source of noise (PC software, sound card) and test with different inputs.
Details nominal signal levels, input impedance, graphic EQ, power rating, and sensitivity.
Details power rating, impedance, frequency response, and magnet type for the M40 speakers.
To Next Page