16
Master Section
This following section details the master section of the mixer.
34. TAPE IN (RCA jacks) - Stereo line
level input, on RCA connectors,
for connecting the output of
devices such as MP3, CD,
computer sound-card, or any
other line level device.
35. TAPE OUT (RCA jacks) - The
signal present at this connector
is the MAIN bus signal before
it has passed through the
MASTER level control and
graphic equalizer. The nominal
output level is -10dBV and the
impedance is 100 Ohms.
36. MON SEND - The signal present at the MON SEND output is sent from the
MON bus, which is fed from the MON send on the input channels.
37. FX SEND - The signal present at the FX SEND output is sent from the FX
bus, which is fed from the FX send on the input channels.
38. MAIN MIX XLR Outputs - The stereo MAIN MIX is sent to the LEFT and
RIGHT MAIN MIX XLR connectors. The signal level at these MAIN MIX
connectors follows the MAIN MIX volume fader. In a live sound applica-
tion, you can drive a speaker system using the MAIN MIX outputs con-
nected to a power amplifier or powered speakers.
XLR Connector pin-out - Pin 1: Ground, Pin 2: Hot (+), Pin 3: Cold (-)
39. MAIN MIX ¼” Outputs - The MAIN MIX ¼” jacks can be connected to a
power amplifier, powered speaker system, or inputs of a digital recorder.
The signal at the MAIN OUT jacks follows the MAIN volume fader.
40. MIX 2 - These line level MIX 2 outputs can be used to drive a second
speaker system or connect to a stereo device such as computer sound
card, MP3, or recorder. The signal at the MIX 2 jacks follows the MIX 2
level control knob allowing you to set a different level at the outputs.
41. PHONES Output - Connect standard ¼” TRS stereo headphones, 60 to 600
Ohms. The PHONES output level is controlled by the MIX 2/PHONES
control.
Top Panel Controls
34 35
36
37
38
39
40
41
To Next Page
Loading...
