Samson MIXPAD MXP144 - Wiring Guide

19
There are several ways to interface the MXP mixer to support a variety of appli-
cations. Follow the cable diagrams below for connecting your mixer.
Wiring Guide
RCA
Pin 1 (shield)
Pin 3 (cold)
Sleeve (ground)
Shield & Cold to Sleeve
Tip (signal)
Pin 2 (hot) Hot to Tip
Male XLR
Tip (signal)
Sleeve (ground)
Tip to Tip
Sleeve to Sleeve
Sleeve (ground)
Tip (signal)
Unbalanced ¼” Connector
Tip (+Signal)
Ring (-Signal)
Sleeve (ground)
Tip to Tip
Sleeve & Ring to Sleeve
Sleeve (ground)
Tip (signal)
Balanced ¼” Connector
Balanced ¼” Connector
Pin 1 (shield)
Pin 3 (cold)
Shield & Cold to Sleeve
Pin 2 (hot)
Hot to Tip
Male XLR
Tip (+Signal)
Ring (-Signal)
Sleeve (ground)
Unbalanced ¼” Connector
Pin 3 (cold)
Shield & Cold to Sleeve
Pin 2 (hot)
Hot to Tip
Male XLR
Tip (signal)
Sleeve (ground)
Pin 1 (shield)