Samson Resound VX8.1 - Getting Started

Resound VX8.1 • Portable Column Array System 7
ENGLISHFRANÇAISDEUTSCHEESPAÑOLITALIANO
Getting Started
The Resound VX8.1 is made up of four sections:
12” subwoofer with built-in amplifier, spacer,
center speaker array with four 3.5” drivers and the
top speaker array with four 3.5” drivers. Follow the
steps below to put the system together.
1. Place the Resound VX8.1 subwoofer on a flat,
steady surface.
2. Insert the spacer section into the subwoofer,
by aligning the four pins on the spacer with
the four holes on the subwoofer.
3. Slide the center speaker array into the top of
the space until it snaps in place.
4. Slide the top speaker array into the top of the
center speaker array until it snaps in place.
Subwoofer Spacer Center
Speaker
Array
Top
Speaker
Array
1
2
3
4