Samson TROVIS 3730-1 - Changing the Displays Reading Direction

76 EB 8484-1 EN
Operation
Table14: Display icons
Icon Meaning Description
Normal operation The positioner is in closed-loop operation and follows the mA signal.
Manual mode The positioner follows the manual set point instead of the mA signal.
S
SAFE
(fail-safe position)
The positioner vents the pneumatic actuator at its pneumatic output.
Conguration
changed
Parameter have not yet been saved in a non-volatile memory
(proceduretosaveinanon-volatilememorydescribedinsection8.2).
Operation locked Congurationisnotenabled.Parameterscannotbechanged.
Fault indication
icon
Amalfunctionordeviceerrorexists(seesection10).
7.2.1 Changing the display's reading direction
Thedisplayreadingdirectioncanberotatedby180°.Ifthedisplayeddataappearupside
down, proceed as follows:
1. Turn until CodeP1 appears.
2. Press
to conrm the selected code. P1 blinks.
3. Turn
until the display is set in the desired direction.
4. Press
to conrm selected reading direction.