EB 8389-1S EN 63
Leakage sensor
9.2.3 Resetting single status
messages
The short-term monitoring (diagnostic param-
eters, measured data and analysis) can be re-
set by selecting and executing the command
"R
eset 'Short-term leakage sensor monitor-
ing". The data in the Measured data assess-
ment folder are reset as well.
Diagnostics > Service/maintenance > Reset
− Reset 'Short-term leakage sensor monitoring'
9.3 Long-term monitoring
To obtain a sound level trend over a long pe-
riod of time, the long-term monitoring con-
tains all the mean values saved in the short-
term monitoring since the last reset:
− 'Mean value': The average sound level
calculated from 'No. of measuring
points'
− 'No. of measuring points'
Data are recorded in the background re-
gardless of the operating mode selected. Da-
ta logging does not need to be activated.
9.3.1 Resetting single status
messages
The measured data of the long-term monitor-
ing are reset by selecting and executing the
command "Reset 'Leakage detection - Long-
term monitoring".
Diagnostics > Service/maintenance > Reset
− Reset 'Leakage sensor - Long-term monitoring'
To Next Page
Loading...
