Disassembly and Reassembly
Samsung Electronics 3-93
No Parts Procedure Remark
6 ASS’Y
CONTROL OUT
1) Disconnect and Separate 5 Connectors
of wire from Assy Control Out.
2) Separate Comp wire and Reactor wire
from each object.
(When you disconnect BLDC motor
connector you have to cut the power
off first and disconnect 30 seconds
later And Make sure that is impossible
to connect and disconnect BLDC
motor connector when the power is on)
3) Unscrew and remove 2 screws on of
Assy Control out.
7 FAN
PROPELLER
+ MOTOR
1) Take Fan Propeller apart.
2) Unscrew and remove 4 screws on
Motor to take apart Motor.
(Use + Screw Driver)
To Next Page
Loading...