3-22 Samsung Electronics
No. Parts Procedure Remark
11 CONTROL BOX f) pull out the connector wire that's on
Inverter PBA.
g) Remove 2 screws that fixing inverter
PCB(A part);
Remove 2 screws that fixing inverter
PCB case (B part);
Remove 2 screws that fixing the plate
colling(C part).
(using "+" screwdriver or electric
motion driver)
* For 14HP models,the number of
screws that fixing inverter PCB is 4.
h) Band the handel of the case and take
off the assy inverter PBA.
(Reffer right pic)
Warning : Becareful when take off
inverter pcb ;when reas-
semble should ensure the
silicon grease thin and
even.
A
B
C
To Next Page
Loading...
