No Parts
Procedure Remark
6) RDisassemble the bolts that are assembled
with the indoor unit at the 4 panel corners.
7) PPress the Steel Hangers at both sides of the
panel inwards, and rotate them 90 degrees
to remove it from the indoor unit’s Hock.
Remove the panel from the indoor unit.
2 Control-Box 1) Disconnect the Connector Wire that is con-
nected to the indoor unit’s PBA from the PBA.
2) Unscrew the 2 fixed screws on both sides of
the Control Box, and disassemble the Control
Box from the indoor unit. (Use +Screw Driver)
To Next Page
Loading...
